Digital Printing Service in Singapore
Artwork Specifications for Digital Prints (A6 / A7)
To avoid unnecessary time delays caused by artwork with design flaws. Please take note of the specifications listed below, please also refer to Artwork Specifications (General) for additional details. If you still have any issues, kindly Contact Us Here, and we will do our best to assist you with your Artwork.
- For A6 Artwork Design, please use the following size:
Bleed Size 152.5mm x 109mm, Actual Size 148.5mm x 105mm after trimming
(Note: Bleed Size is not always required, you may send in Actual Size without Bleed if there is no printing at the edge) - We recommend that any important elements such as words / images and border frames / lines be kept within the Safe Area (5mm away from the edge) to avoid them being cut off and accommodate for cutting error.
- All Artwork Design needs to be above 300dpi to ensure good printing quality. Artwork Design with small text would need to be a minimum of 400dpi.
(Example: If you are printing A6, you need to send us an Artwork with the Bleed Size of 152.5mm x 109mm. The Bleed Area is 2mm, but you may Bleed up to 5mm if needed. Any important elements should be kept within the Safe Area of 138.5mm x 95mm, which is 5mm away from the edge)
- For A7 Artwork Design, please use the following size:
Bleed Size 109mm x 78mm, Actual Size 105mm x 74mm after trimming
(Note: Bleed Size is not always required, you may send in Actual Size without Bleed if there is no printing at the edge) - We recommend that any important elements such as words / images and border frames / lines be kept within the Safe Area (5mm away from the edge) to avoid them being cut off and accommodate for cutting error.
- All Artwork Design needs to be above 300dpi to ensure good printing quality. Artwork Design with small text would need to be a minimum of 400dpi.
(Example: If you are printing A7, you need to send us an Artwork with the Bleed Size of 109mm x 78mm. The Bleed Area is 2mm, but you may Bleed up to 5mm if needed. Any important elements should be kept within the Safe Area of 95mm x 64mm, which is 5mm away from the edge)
